Expanded Polystyrene rigid board insulation for ground floor applications.
Suitable for use in ground supported or suspended concrete floors.
EPS70 is primarily used in residential buildings; higher grades (EPS100 - EPS200) are available on request, for commercial and industiral uses.
Easy to cut and shape.
Can be used to improve reliable long-term energy savings for buildings.
Thicknesses and Availability:
Available in most popular thicknesses at most depots; short lead-times may apply if we need to get stock in before delivering to site.
This EPS70 Range includes the following readily available product thicknesses: 25mm, 50mm, 75mm, and 100mm.
Other thicknesses, in incriments of 5mm, can be supplied on request. Please allow extra lead times as these items will need to be manufactured.
General information about Kay-Metzeler EPS70
Ground floor insulating board
Kay-Metzeler's EPS (Expanded Polystyrene) foam board, EPS70, is suitable for use in ground supported or suspended concrete floor applications.
Kay-Metzeler EPS70 is manufactured from expanded polystyrene (EPS) that has zero ozone depletion potential (zero ODP) and low global warming potential (GWP).
|Thickness||25mm to 100mm|
Buy Kay-Metzeler EPS70
Reasonable stock levels are generally held at most of our depots. In some geographic locations, depots may stock alternates, however, we will contact you to discuss before proceeding with the order.
Where products need to be brought in from Celotex, please allow approx. 1 week for delivery.
- Generally 1 or 3 working days for delivery
- Generally 1 to 5 working days for delivery
- Generally 5 to 10 working days for delivery
- Special request or made to order item, allow extended lead times. Minimum order levels may apply.
- Please call to check availability and approximate lead times
Product availability depends upon stock levels at closest depot and delivery logistics to geographic locations
Product Performance and Guides
Product Performance, Manufacturer Downloads, and Installation Guides
|Thermal Conductivity||0.038 W/mK|
|Compressive Strength||70 kPa at 10% compression|
|Vapour Resistance||100-200 MNs/gm|
|Nominal Density||15 kg/m³|
|Kay-Metzeler EPS70 25mm||25mm||0.65 m²K/W||0.37 kg/m²|
|Kay-Metzeler EPS70 50mm||50mm||1.31 m²K/W||0.74 kg/m²|
|Kay-Metzeler EPS70 75mm||75mm||1.97 m²K/W||1.11 kg/m²|
|Kay-Metzeler EPS70 100mm||100mm||2.63 m²K/W||1.49 kg/m²|
Kay-Metzeler is CFC/HCFC free with zero ODP and low GWP. Kay-Metzeler EPS is manufactured in accordance with quality management system ISO 9001 and environmental management system ISO 14001. All products must be installed in accordance with guidance issued by Kay-Metzeler.
Where building regulation approval is required, you should take advice from your local building control authority and the building designer.
- 01245 342 104
- 01245 342 122
- [email protected]