5 to 10 working days
Premium performance rigid Phenolic pitched roof board
Replaced Kingspan Kooltherm K7.
New lower Lambda Value (Thermal Conductivity) 0.019 W/mK... The most thermally efficient commonly used insulating board.
Used for insulating pitched roofs at rafter level, between ceiling joists, cold pitched and flat roofs.
Premium performance rigid thermoset fibre-free phenolic insulant.
Unaffected by air infiltration. Resistant to the passage of water vapour.
Thicknesses and Availability:
Available in most popular thicknesses from the manufacturer; short lead-times apply as we may need to get the products in from Kingspan before delivering to site.
This Kooltherm Range includes the following readily available product thickness: 25mm, 40mm, 50mm, 60mm, 70mm, 75mm, 80mm, 100mm and 120mm.
The following thicknesses are manufactured to order: 90mm, 110mm, 130mm, 140mm and 150mm; these may carry minimum order levels.
5 to 10 working days
|Kingspan Kooltherm K107 25mm, 12 x 1.2×2.4m = 34.56m²||£472.16|
Kingspan Kooltherm K107 is sent out from depots nationwide and is subject to the Local Depot Delivery minimum order levels and delivery charge thresholds.
Limited stock of the most popular boards sizes may be held at some of our larger depots, and thus, available on shorter lead times than the availability rating suggests.
Kingspan reserves the right to change stocked products - while we will do all we can to keep on top of changes, availability and lead times may vary.
Delivery charges will be calculated at check-out. Please visit our Ordering From Us page for further details on minimum order levels and delivery charges. If you have any queries, please do not hesitate to contact me.
Pitched roof insulating board
Kingspans premium performance lower-lambda value phenolic foam board, Kooltherm K107, is suitable for use in above, between or below rafter level applications as well as dwarf walls and loft floors.
Core: Kingspan Kooltherm K107 Pitched Roof Board is a premium performance fibre-free rigid thermoset phenolic insulant.
Facings: Faced on both sides with a low emissivity composite foil, autohesively bonded to the insulation core during manufacture. This reflective, low emissivity surface improves the thermal resistance of any unventilated cavity adjacent to the board.
|Thermal Conductivity||0.019 W/mK|
|Compressive Strength||100 kPa at 10% compression||BS EN 826:2013|
|Nominal Density||35 kg/m³|